This post and its photos may contain affiliate links. As an Amazon associate I earn from qualifying purchases.If you make a purchase through these links, I may receive a small commission at no extra cost to you.
I was thrilled to be a creative guest on Ucreate a few months ago where I shared my Braided Ribbon and Chain Necklace. Then, today, I was looking through my drafts and realized I never shared it here. So I realized it would be fun to recap and share with all of you – just in case you missed it.
Doesn’t that look easy? I’m going to be honest, the hardest part about this necklace is deciding which fabric flower to add.
This is all you need:ribbon, chain, fabric swatch, needle and thread, pliers, and scissors
The first thing you need to do is decide how long you want your necklace to be. It needs to be long enough to slide over your head. I made my finished necklace 30 inches so I used chain that was 32 inches and cut the ribbon around 64 inches. You can make it any length you want it to be, just remember the braid causes the finished necklace to be shorter than what you start with.
To start making your necklace, pull one end of the ribbon through the first link of your chain. Keep pulling until you have an equal amount of ribbon on each side of the chain.
Now that you have your three strings, you are ready to start braiding. You can make it as tight or loose as you want. Keep braiding until you get to the end of the chain.
Once you come to the end of the chain, thread one piece of ribbon through the last link and tie the two ends of the ribbon to form a tight knot. This will keep the braid from coming undone. Don’t worry if it doesn’t look perfect. We will cover it up with the fabric flower.
Use the pliers to attach each end of the chain together.
And our necklace is finished!
Now we are ready to add the fabric flower.
This is the hard part because there are so many great ways to make fabric flowers.
I made this flower by cutting12 circles from a lightweight rayon fabric. I stacked all but 5 of the circles on top of one another a little off center. Then I took the last 5 circles, folded each one in half twice and layered those on top of the flat circles. I used my needle and thread to stitch it all together. Twist the folded circles around, fluff it up, and you have a great looking fabric flower!
Using the same needle and thread, attach the flower to the ribbon where the two ends were tied together.
Finally, show off your fabulous new necklace that you made and enjoy all the compliments you get!!
How simple is that? So easy that you will have time to make one for yourself and to give as a fabulous gift. You can make them in different colors, use various widths of ribbon and fun, funky fabric flowers. I think a pretty fabric rosette would be really pretty. The possibilities are endless.
I hope you have fun making your own Braided Ribbon and Chain Necklace with your favorite fabric flower.
great job! thanks for sharing 🙂
Very cute! Pinned it and posted about it on my blog today! Have a great Tuesday,
Fun necklace! Love the braided ribbon and chain detail.
Fabulous! Great job!
One Chatty Chic
Oh, I like that! I wonder if you could put the flower on a pin back or something and make it interchangable.
How cute and clever! I love how this turned out. Stopping by from Family Ever After. Thanks for sharing!
I absolutely love this! I’d love for you to share it in our link party!
~Natalie @ Crafty Cousins
Holla! We’re your newest followers! 🙂
You make this look so easy – I must try this!
Thanks for sharing at Fabulous Friday! I am featuring you!
Thanks for sharing Kara 🙂 http://felting.craftgossip.com/2013/01/17/braided-ribbon-and-chain-with-a-flower-necklace-tutorial/